Identify the table construction before turning a tool
Photograph the table from above and below, then record its length, width, height, material and approximate weight. Note extension leaves, pedestal bases, removable legs, glass or stone tops, drawers and powered features. Count the chairs and identify loose seats, arms or existing weak joints.
Find the manufacturer and model instructions. IKEA Canada, for example, directs customers to the product page's assembly-and-documents section and uses part codes for many replacement fasteners. The existence of visible bolts does not prove that a table is intended to be separated in the order that seems obvious.
Map and label every removable piece
Photograph each connection before disassembly. Give legs, bases and leaves simple labels that show their original position. Put original fasteners in a sealed, labelled bag and keep the bag with the table's parts container. Do not mix chair hardware with table hardware or substitute longer screws at reassembly.
Support the top while a base or leg is removed; do not let its weight hang from the final fastener. A glass, stone, antique or damaged top may need a specialist handling method. If the top is bonded, cracked or unusually heavy, stop and have the scope assessed instead of forcing it apart.
Protect tops, leaves and chairs separately
Do not tape chairs into a nested stack unless the design and protection make that safe. A chair can look light while its back creates an awkward lever. Existing loose joints should be photographed and kept out of the normal carrying route until the crew understands the condition.
- Clean loose grit before applying suitable protection.
- Keep adhesive tape off wood, upholstery, glass and finished surfaces.
- Use rigid corner and edge protection where appropriate.
- Pack extension leaves as individual finished panels and label their orientation.
- Keep chair legs, backs and arms from carrying stacked weight.
- Disclose cane, veneer, loose joints, glass inserts or delicate finishes before loading.
Measure the prepared pieces and route
Measure the largest protected component, not only the assembled table. Check door openings, stair landings, elevator doors, corridor turns and the legal loading location at both properties. Record overhead fixtures and wall corners that affect a long tabletop.
CCOHS recommends planning workflow, using mechanical aids where possible, reducing repeated handling and ensuring clear access. Use enough people and appropriate equipment for awkward pieces; do not lift a tabletop alone simply because it is thin. Keep handlers' views of stairs and turns clear.
Reassemble without forcing alignment
Place the protected parts in the destination room and compare them with the recorded diagram. Follow the manufacturer's sequence, use the original fasteners and tighten as instructed. Check that leaves, locks and moving parts align before placing weight on the table. Reassembly does not include furniture repair unless separately agreed.
For a Parkside Movers quote, provide the table dimensions, material, leaf and base design, chair count, model if known, disassembly request and both access routes. State whether glass, stone or antique components are present so acceptance and handling scope can be confirmed before moving day.
Planning a move?
Tell us what you need moved and share any access details for a quote.
Request a quoteExplore furniture moving ↗